Does anybody on here know the location of the blue & me unit ???

Also the fuse for it...if there is a separate fuse :-S

Its located under the passenger seat, there is a cover over it. There is a seperate fuse for it, but the workshop manual is offline for maintenance, so ill check that later

Thank you very much. I'll be very grateful if you could !

F01 60A, located in the fuse and relay box in the engine compartment
F36 10A, located in the BCM 1st row, 3rd from below
F51 5A, located in the BCM, 2nd row (closed to steering wheel), 3rd from a above

FiatTecie said:

F01 60A, located in the fuse and relay box in the engine compartment
F36 10A, located in the BCM 1st row, 3rd from below
F51 5A, located in the BCM,


2nd row (closed to steering wheel), 3rd from a above

Click to expand...

thank you my friend! The unit under the cover, is it the black plastic cover. Same as the one under the drivers seat? If not what are those for!?

woooooo found it! Thank you.... Fuses ok , think I'll just have to replace the unit itself. Bugger.

No warranty left? Do you use a USB-flashdrive? If yes, only use a FAT32 formatted version and only .MP3 files, others types of files are know to cause isseus and/or destruction of the units EEPROM. The dealer can some times do a force reset.

FiatTecie said:

No warranty left? Do you use a USB-flashdrive? If yes, only use a FAT32 formatted version and only .MP3 files, others types of files are know to cause isseus and/or destruction of the units EEPROM. The dealer can some times do a force reset.

Click to expand...

sadly no .... Bought private, warranty has ran out. It hasn't worked since I got it.
I'm just working my way through the list of possible solutions lol.


I've already done a proxy alignment as I had the flashing mileage... Everything points to a knackered blue&me box. Have found secondhand ones for around £100.


everything works EXCEPT blue&me, the rest of the steering wheel controls are fine.

You know that there are two types of blue and me modules? Magnetti and Lauberrhorn both made them, and as far as i know, they can not be switch over

FiatTecie said:

You know that there are two types of blue and me modules? Magnetti and Lauberrhorn both made them, and as far as i know, they can not be switch over

Click to expand...

yes mate ,I've found the label on the side etc . Gonna match it up mines magnetti.

well that was short lived! I purchased another blue and me unit , tis compatible ! fitted it , scanned everything it all seems to be in working order , done the proxy again.....STILL NOTHING!

a couple of intermittent errors occur u1733-convergence node
u0019 - B-CAN line

I clear these but still doesn't work , the unit itself is in working order as the scan recognises it etc......what the flip!

That must be so frustrating. We feel your pain.

lol.......a blemish on an otherwise perfect car!