The 750L has developed a leak from the water pump. Where the pipe goes into it from the radiator pipe.

I done a coolant change on it not to long ago and had to do some wigling of the rubber to get it off. In doing this I think I've affected the seal on the pipe/pump.

How do I need to go about sorting this?

drain, remove metal pipe, fit new seal, cheap from fiat, refit refill. you undo the 1 bolt and metal pipe just pulls out

when you say fiat for the seal,any fiat dealer? or you know of one who is more symphatic to older cars? nice you can still buy the seal, what about the pipe it`s self?

there`is an updated seal iirc. i think the seal is same for all 8v fires but panda may have different pipe at other end.

I usd an O ring from an O ring set I bought from aldi and a bit of instant gasket on BEX. Worked a treat

Cheers all. Dave is the metal bolt the one holding the pipe in place about half way along?

Yes thats the one.

While you have the tube off check it for rust. Mine was shot but a lot of leak fix and some brown string worked rather well. It had a small hole right on the bend.

All spot on info...

yup, bang on, just changed that pipe on grumbleweed for a new one a few days ago as the old one was getting pretty hard up, push fit with an O ring and one bolt to hold it in place. I fitted it with some instant gasket to be on the safe side too.