Hello,

I have just bought another Sisley to put the interior into my Sisley as its much nicer as the Sisley interior was missing from mine.

The interior is fine which is all i wanted from it but I wanted to put my interior into it then sell it but it has a big ignition wiring problem.

I know this sounds extremely dodgy and I don't blame you but I promise you that this is 100% legit.

Basically the previous owner had a load of wires go up in smoke and has replaced all the burnt wires but forgot to mark all the wires prior to pulling them all off the ignition barrell. I have tried to piece them all together and have managed to get the ignition to come on but thats about it.

Does anyone have an ignition wiring diagram or has successfully done this job before?

I really want to get it all back together so that I can sell it as all I wanted was the interior.

Many Thanks,
Neil.

P.S - I can supply pictures of the current wiring state if needed.

Bump..

there should be a digram of the wiring in either of the popular servicing manuals...

if you haven't got one of these... i'd get one. bear in mind that without the original colours it's going to be tough either way.

I've got a manual. Not the Haynes one though but iirc it was pretty detailed. Will dig it out and see if it has a wiring diagram.

Cheers