Technical OBD 2 compatable for a 2004 multipla

Currently reading:
Technical OBD 2 compatable for a 2004 multipla

Hi Think that's what I had hold of and unplugged the top 3 wires 2 grey a blue stripe and I wasn't sure if it was a bolt or screw further down but I didn't want to take it off encase wrong. The spec page you have a pic of don't no if its the same one I have on disc manual but cannot find out on it yet. cheers once again.


Hi got it off must of been first time since it was new . Very tight rusted up first few threads when I got it removed it was fully carboned up so it must of wanted cleaning for a goodtime .So got all the carbon off front and plenty came out from inside. Got it back in and tighten so I will have to reset it too take the light off and see if it stays off while I'm driving about. Put a picture up to show what it was like.
 

Attachments

  • 044.JPG
    044.JPG
    2.9 MB · Views: 17
Hi Peter
I had a look at the sensors and has you say they are not a great expense to pay so I will get 1 order has they have a chip in so if its not reading properly its no good going from one thing to another at least its new and I no it will remove and change quicker because of taking it off all ready before. cheers for the help all.

As you may have noticed, Mister-auto offers several different sensors, so be sure you order the correct one for your car, check the part number on ePER on top of this page, before ordering...
 
Last edited:
Back
Top