The new car!

There are a few bits which I'll be doing urgently - the paint could do with a good polish and bits need spraying... more rattle cans lol

Needs a new bonnet ideally as it's got a few dents from the previous owner parking too far into a space...

Plans:
Bebadge
Standard alloys (multispokes are a bag of arse to clean)
Bonnet
Colour code mirrors
lower it
sort out engine bay a bit

nice

still wont replace your mk1 tho... loved that car....


BTW you need to change your sig.....lol

Looks good, I like multispoke alloys but can appreciate how hard they are to clean from just cleaning multispoke look-a-like hub caps, you think the light bodywork will take much dedication? It doesn't seem obvious at all but that might be due to the image sizes.

why is the front so high, have you taken engine out?

yeah, i thought it looked too low with the engine in...

I expect to lower it at some point but got to pay back the loan before I can start...

what year is it?

way! happy 4 ya m8ey

2000 "w"

, looks nice Adam, when you sell them multispokes give me a pm.

Will do mate

I'm after some standard sporting alloys first.

Welcome to the bright side

looks good in the pictures.


now all you need is the ability to go down low

Looks good

lol - the only issue at the moment is money, and need to sort a problem I seem to ba having with the throttle not opening right, seems to be "lumpy" like it opens in stages, rather than freely

The bodywork, other than the bonnet and bumper is completely mint - washed, ITR'd (intensive tar remover) and T-cutted the both sides, boot and rear spoiler today, before 2 washes and waxing.

no t-cut it use clay

whip throttle body off and give it a clean with injector cleaner spray an a tooth brush

oh wear rubber gloves, it dries skin out well bad

lol - I'll give it a go at some point.

I used T-cut as the passenger side had lots of small scratches on it (like when you go down a country lane and a van goes the other way, you get that tiny bit too close to a bush...)