binhoker

Chinese air filter will do for now

engine and gear box is in. still dealing with some rust patches prior to repainting bonnet. i have replaced ignition module coil and...

i have just rebuilt one and have some parts if you end up going down that road

I have some parts I am not using. but not sure if stepper motor is alive

i skimmed the cylinder head on Fallout using a sheet of fine wet and dry sand paper, 5x 1kg weights, a sheet of glass, ply board, and a...

cleaned up the valves for lapping today then noticed a lot of play in the exhaust valve guides. so gonna use the other head, my steel...

it doesn't taste like licorice

bottom end is rebuilt now. my gasket set came with a bit of rubber looks like a piece of licorice. no idea where it might go. maybe for...

so the block of engine 2 is now totally stripped, bores look good, rings that in have checked are within tolerance. some rings are...

i have 2 starters for 999cc engines her both are magneti marelli 63221890 and have 9 teeth. i just bought a replacement of eBay as...

right gona order a head gasket and valve seals. i rebuilt Mercedes top end awhile back after timing chain failure. engine ran grand...

On the various engines I have rebuilt over the years, even if I don't intend spending much money on them, whilst stripped, the least I...