Any Eper buffs?

anyone got Eper and mind getting me a couple of part numbers at all?

Need part numbers for nuts/threaded rods for the throttle body and also the part number for the gasket between the top and bottom of throttle body

Drink at skeggy for anyone that can help?

Think I have a spare TB sat on my floor if you can wait till stanford and bring a tenner?

dont need a tb just unused gaskets and bolts think its the cause of my slight boost leak

Well the TB has both of those bits.. also may have some in my parts box but if you want to buy new fine

nah wanna get fresh ones thx anyway tho fella

Hang on a sec.

Liam

this was all covered on msn hours ago liam

dunno was you afterall Lol


Part codes i think:

big spacer bit - 46405881 (Is this for the bit between the top and bottom half of tb btw custard?)
7738332 shown as screw and washer ass for those big rods?

Threaded rod 7786326 £2

Nuts 60809794 £0.50

What gasket do you mean, the one with all the cut outs?

Liam

is the gasket for inbetween the top and bottom half of the tb, like a orangey colour iirc? (not that epers in colour, but you may remember seeing one? )

Someone should update the thread then!

Liam

can anyone check those part numbers at all?

Couldnt remember but apparently there is 2 bolts through the TB into the inlet, and then the rods out of TB to the plenum top? so need 2 seperate part numbers (parts guy wasnt sure of these lol )

and the spacer, parts guy seemed to think that part number was for the spacer that sits inbetween tb and the inlet manifold, but i need the cork spacer type thing that goes inbetween the 2 halves of the throttle body...

need the spacer that sits on top of this bit;
http://www.fiatforum.com/attachment....7&d=1112292865

pleaseeee help if you can, need to get my bits sorted so i can re-fit this TB and pray it fixes my prob

sorted i think he has to order it all in though he'll get it on sat and send it out to me then yay

or not on backorder with no date

K Eper Buffs i need your help, i have an eper DVD, i've installed it and configured it but when i press, the "Start Eper" button the browser loads but its a blank screen, any help would be good??

Regards
Donny (no not osmond)