Technical clutch pedal stucks in lower (pressed position)

Currently reading:
Technical clutch pedal stucks in lower (pressed position)

rbosko

New member
Joined
May 14, 2014
Messages
5
Points
3
Hello everyone,
my problem is that clutch pedal sometimes stays stuck in pressed postition. I can release it by my foot. Maybe I press pedal to hard or it is something else. It started to happens 10 days ago. I can change gears normally during drive, this happens only when the car is stopped and I want to shift in 1st gear or in the reverse. Please help me. I don't want that some mechanic replace me all the parts if it is not necessary.
 
Hello everyone,
my problem is that clutch pedal sometimes stays stuck in pressed postition. I can release it by my foot. Maybe I press pedal to hard or it is something else. It started to happens 10 days ago. I can change gears normally during drive, this happens only when the car is stopped and I want to shift in 1st gear or in the reverse. Please help me. I don't want that some mechanic replace me all the parts if it is not necessary.

Hi, I've had an accessory mat get caught before, :eek:

check by crawling into the footwell and push / depress the clutch pedal by hand.

see it what point it seem to go tight/ stiff.., it MAY be the actual slave cylinder on the top of the gearbox..,

but try clearing obstructions ( carpet / cable, etc

AND lubricating the pedal mechanism with oil / WD40 / etc,

Charlie
 
It would be too easy that the mat is problem. :)
I think that problem is slave cylinder, some squeaking noise comes from under the hood. WD40 does not help. Tomorrow I'll replace it and I will let you know.
Thanks
 
There have been a few people experience similar on the Panda. I think mine was the master cylinder, but I replaced both it and the slave and all is very smooth now. It seems to be what happens when plastic cylinders wear. Check if the cylinders are plastic on yours.
 
Back
Top