wiring problem subs to amp

i have two pionner 1200w champion series subs in separate boxes with a 3000w loudest amp my amp looks like this - - + +

i have wired atm the negatives from each sub to the two negatives on the amp and the two positives from each sub to the two positives on the amp is this correct please help me sorry dnt know how to up load a diagram of what i have done

From what I've seen on most amps if you have two subs then you should wire it like so................

+ SUB 2
+ SUB 1
- SUB 1
- SUB 2

(Imagine that turned on it's side to look like your little diagram)

Every amp I've ever used were wired like so but yoursmay be different.

Is it a 2 channel amp or a mono amp?

its a monoblock amp which look like this on the side --++

Ahh you need to wire to 2 ohms then
Ignore the green wires.
Or in word wire the +on sub 2 to to the + on sub one, same with the - and then the + from 1 to amp and same with -

sorry forgot link

What model subs are they?

they are pioneer 1200watt champion series subs

That's not what I meant - what voice coil config, since they come in more than one IIRC.

Ts-w307d2

Well aparently it is dual 2ohm and i believe that the amp claims to be stable at 1 if you wanted to wire it like that but then you run the risk of overpowering them but do we believe the loudest's RMS Claims

Not really!!!

Anyways....

If they are dual 2 ohm that means either 2 x 4ohms or 2 x 1ohm, so either way can show the amp 2ohms. Just don't wire them so they show 0.5ohm or chances are the amp will go into protection mode or up in flames!

That thing will prob do that at 4ohms