Fitting Headlamp Protectors

I know these may not be the most stylish "mod" but would rather have these than a bill for new headlights.

Step 1: Throw away the Fiat instructions, probably the worst I have ever seen.

Step 2: Open the bonnet and push the protector onto the relevant headlamp.

Step 3: Fit the plastic clips into the hole on the metal clip and push the brass threaded nut into the hexagonal hole.

Step 4: Slide the metal clip under the headlamp cover and align with the slot on the protector.

Step 5: Clip the metal clip over the back of the headlight.

Step 6: Push the screw provided through the slot in the headlamp cover into the plastic receptor on the clip and screw into place, be careful not to over tighten.

Steo 7: Close the bonnet step back and think, mmmmmm, not to bad but could have been better.

These took about 5 mins to fit in total.

Cheers

Paul