Technical Ducato X250 with toad ai606. CDL problem

Currently reading:
Technical Ducato X250 with toad ai606. CDL problem

mreurostar

New member
Joined
May 18, 2013
Messages
1
Points
1
Hi
I am a newbie to this forum, so please be patient with me.
I have just purchased a 2013 Ducato camper van 3 liter auto. I had a Toad AI606 fitted but have got a problem with the CDL. The approved alarm fitter for this alarm cannot resolve the problem even after two extra visits to have this investigated.
Basically, the problem is that when you press the alarm lock button, the doors lock and the alarm is armed ok. You then unlock and disarm, this works ok. The problem is that if you try to lock again without opening the doors, the alarm arms but doors do not lock. press unlock and lock again and this time it works.
This happens every time. Also works if you press unlock/unarm before lock and
then it locks again. its as if the system needs waking up.
All is wired to the Ducato wiring diagram for this alarm
CDL Type MULTIPOINT NEGATIVE
Lock BLUE/YELLOW WIRE PIN 53 IN A 60-WAY GREEN CONNECTOR AT THE FUSEBOX
Unlock WHITE/PURPLE WIRE PIN 50 IN A 60-WAY GREEN CONNECTOR AT THE FUSEBOX
Unlock OR SAME AS THE LOCK WIRE BUT VIA A 680 OHM RESISTOR IN LINE ON THE UNLOCK WIRE

Any ideas please
 
Back
Top