hello again! the next problem i have is the heater fan spead, it started to only work on setting 4 or off about 6 months ago, then recently it stopped working all togethor. i have replaced the heater control unit with another from ebay which was a tricky job!
i probably should have taken a photo but didnt think at the time:bang: when changing the unit there are two plugs on the back, 1 for the two lights which was fine, the one that plugs in behind the temperature / speed switch. However, had one of the four wires slightly melted showing bear wire but was still connected to plug.
anyway the heater is blowing again but only on setting 4 again which is better than none at all i suppose
I have herd that it could possible be a resistor that is the problem and could anybody explain where abouts this is or have i purchased another stuffed control unit (which wasnt cheap even second hand)
Again thanks in advance Ian
i probably should have taken a photo but didnt think at the time:bang: when changing the unit there are two plugs on the back, 1 for the two lights which was fine, the one that plugs in behind the temperature / speed switch. However, had one of the four wires slightly melted showing bear wire but was still connected to plug.
anyway the heater is blowing again but only on setting 4 again which is better than none at all i suppose
I have herd that it could possible be a resistor that is the problem and could anybody explain where abouts this is or have i purchased another stuffed control unit (which wasnt cheap even second hand)
Again thanks in advance Ian