I have a 2011 doblo with a dented front wing. I have bought a replacement wing, has anyone done the replacement themselves and can offer some advice?

Is it purely bolts or is there adhesive? Anything else i will need to remove to get it off?

Roughly how long will it take?

Anything to be wary of that may catch me out?

thanks!

I've got one now and I need to paint a rusty wing. I've got the same questions. Did you do the job? Are you still a member of this forum? .......Am I being optimistic?

Hi, I done this job a few weeks ago and it’s easy enough, mostly just blots but there was one bolt in the wheel arch that was covered in sticky crap that I could not get rid off so I had to get the angle grinder to it. Putting the new one in is easier but my advise would be to finger tighten the bolts first so you can adjust the wing and then tighten properly. Took about an hour to do most of which was getting the old one off. Good luck.