Well how meany of you find the twin rear doors stiff to open\ close
Small mod to hinges there is NO way to get oil into the pins so you have to make one, at the top of the part welded to the door drill a 3mm hole start it off square to hinge then tip the drill to 30\40 degrees, drill till you just go into the pivot pin blow any cr*p out you can now oil the pin.
Found oil would not trickle in to start with so used diesel for a day or so working the door the full open close when it loosened up I then used 3 in one from their plastic squeeze bottle the spout fits 3 mm hole you can push it in & squeeze to help while opening & closing door.
Small mod to hinges there is NO way to get oil into the pins so you have to make one, at the top of the part welded to the door drill a 3mm hole start it off square to hinge then tip the drill to 30\40 degrees, drill till you just go into the pivot pin blow any cr*p out you can now oil the pin.
Found oil would not trickle in to start with so used diesel for a day or so working the door the full open close when it loosened up I then used 3 in one from their plastic squeeze bottle the spout fits 3 mm hole you can push it in & squeeze to help while opening & closing door.
Last edited:
