Hi chaps. Wonder if any of you can measure the width of the back seat for me and also the measurement between the belt release in the centre. I currently own a stilo multiwagon but am struggling with 3 children seats in the back.

Thanks in advance

Robin

3 recaro wouldn't fit but 3 mummas n puppers probably would

i think some one here with a 2.4 lives nearer to you than me, but if he don't offer you could test fit in my car

Robin,

Just popped out with the tape measure - all measurements inside the car with both doors shut (there is no intrusion from the rear armrests etc over the seat cushion). All of the belt release distances are to/from the centre of the release pads for consistency. As accurate as I could be, but possibly a few mils either way.


Back cushion is 25" (63cm) high - not including headrests.

Bench cushion is 55" (140cm) wide and 20" (51cm) deep.

The distance from either offside/nearside belt releases is 19.5" (50cm) to their respective cushion edges.

The centre belt release is 16" (41cm) from the nearside belt release.

Hope that all makes sense.

Welcome to test fit in mine, but finding time over the next week or so may be challenging. Where abouts are you?

Have you seen a particular Croma for sale you are interested in?

Bob

Also it looks as though there are 2 isofix points in the rear if that helps.

That's right Brian - they are each outer side of the rear bench cushion.

Some info about this in the handbook (pages 109/110) which can be downloaded from this link: https://www.fiatforum.com/downloads.php?do=file&id=130

Thank you all for your replies.... i will have a measure up of my stilo rear bench and see what that is... i have seen a 06 plate prestigo 3 miles from where I live, fully loaded with the 1.9 16v 150 bhp engine.

bi just wanted a rough idea, that way i can go and have a look without worrying it was gonna be too small.

Thank you all once again

Robin

I am in Chelmsford, if anyone is local to me?

The ISOFIX points are positioned so that they take up a lot of room.
I have a FamilyFix base in the back, but it does start to encroach on the middle seat slightly. Even more so when the baby seat is on.

Might be a squeeze if they're using bases etc... Should be fine without

This might help as a guide to where an isofix base sits.

SkinnyandWirey said:

This might help as a guide to where an isofix base sits.

Click to expand...

thanks buddy, I don't have bases like that anymore, there in booster seats and 2 of them have the backs on still, its very tight in the stilo

so been a while, but now i am thinking about the croma again, middle seat is the one i worry about, in the stilo its only 9" wide and is ever so tight for my daughter to fit in with my daughter and son the other side of her.... have just start looking again

How wide's the car seat and I'll measure mine if you like?

BrianMcL said:

How wide's the car seat and I'll measure mine if you like?

Click to expand...

thanks Brian, i already have the measurments now the stilo has gone to its new owner, i can start looking again, still not 100% as i may get another make, vauxhull, renault, ford, citoren, or honda but haveinga good look round