Re-maps/ Chips/ Boost gauge

Can anyone recommend a good vendor for either of the above... Would like this done but not by some cowboy that'll cos it to over fule and my car to end up with its engine sharing a plot with Tommy Cooper!!

Ideally in scotland but happy to travel for quality work.....

Does anyone have a boost gauge fitted and where? wot boost does the 20v T run as standard?

( I should start all my posts with "Spunky M can you tell me..") :D

kenny f

travel for re-map yo here http://www.angeltuning.co.uk/

they are good one of the directors is a member of ff and members have used them and been very happy

----------------------------------------------------------------------------------
Please do not Email or PM me asking for support. Post on the forums instead. Your reply may help someone else. Thank you

No experience of Angel Tuning but you are definitely right to get the fuelling checked on a wide band lambda after getting any aftermarket chip fitted. You can go for a pre-programmed chip like Novitec, Digitec, Graham-tec, Superchips, G-Tec or just about anything ending in Tec :D or one that is mapped in real time specifically to suite your car like the Dastek Unichip. I would say there are definite advantages to the latter but it is more expensive of course.

Boost gauge - have a look at my install here...

http://www.rig.org.uk/shi/coupe/New%20Folder/howto5.htm

(It might be neater to route the piping through the grommet for the bonnet release).

Std boost for 20VT is 1 to 1.1 bar.

SpunkyM...
Fiat Coupe 20VT, Bailey DV, K&N panel, PBV @ 1.1bar.