Nice to have you back
Not much happened since you've been gone, my car still isn't finished.

Two weeks, that's a bit long for you.

Mate! Nice to have you back! You been away??

Haha, keeping my eyes on this thread, are you gonna be going to Brooklands?

Knowing you Andy this will all swapped in a weekend. Look forward to seeing progression

I won't be going brooklands as I have an appointment with my surgeon a couple of days before and I'm always in pain for a few days after so won't be able to get around properly.
Been gone for at least 3 years but have looked in occaisionally. Some will know what I've been going thru from Facebook and trying to bounce back from my depression but all the back pain doesn't help so over last 2 years I've thrown myself into my work doing upto 20 hour days. Going under the knife in a few months after scans are done and going to be off work for 4-12 months so Cinq has to be done before then!!! But back problems is why it's going to be done slowly and I have to fit it in around my job as going to do the conversion at work so I have air tools and the ramp so will be a lot easier for me.
This is as she stands at the moment

Great to have you back Andy! Hope all goes well with your surgeon/op.

Please don't use a big ass DTM exhaust again .

Welcome back by the way .

Thanks

X

Trying to sort the bloody wiring again and can't figure it out as lost my list of wiring connections that did work from my original conversion can anyone give me correct wire colours for d4 please

I just followed Dans guide and it fired up first time for me so pretty sure it's right. Someone needs to write a definitive guide using pin numbers rather than colours so differences in colours of looms don't matter. I swear some must have different colours for all the issues people have on this. I did write it on a scrap of paper when doing mine but lost it as was moving house at same time.