Technical confused on cylinder head

Currently reading:
Technical confused on cylinder head

Joined
Aug 24, 2009
Messages
2,400
Points
480
Location
Telford
i got bored today and decided to strip off the head just for the hell of it

the production code in ePER was 71735496
but stamped on the side of the head was 46400108

only reason im asking that is because the water galleries are slightly different to the head gasket

DSC00487.jpg

DSC00488.jpg

DSC00489.jpg

i would of thought it would be one big hole rather then two smaller ones unless they are meant to be like that :confused:

the previous owner replaced the gasket 5000 miles ago and he said it was well looked after :rolleyes:

any info would be appreciated on this
ASH
 
it's meant to be like that :)

if you've done it 'just for the lolz' then i do hope you know it'll need a new gasket and ideally need new headbolts and the head skimming before refitting.
 
Last edited:
Back
Top