(G) Mot

how many seats will i need in my car to pass MOT cheers ,, i obviousley have the drivers seat in but none others ,

pmsl why have you took out your seats?

1 seat is fine as long as its drivers Remove all seats and seat belts etc.

They may frown on your harness mounting though, so thake it out and use normal belt.


Kristian

hummm thats the problem on my bucket seats there is no where to mount the seat belt clippy thing witch the seatbelt clips into. , at the moment i have drilled a hole into the side of the subframe and clipped the harness bit through that but im worried that there going to fail that .

because i am making subframes for my buckets and only done drivers so far not enough time to do passengers so far , and back seats i just dont want in there .

I'd take it in...see what they say. In this area they are purely looking at safety, and so I'd take anything they say as usefull information.

You will get a free retest. My latestest tester let me have 4 or 5 tests free


My probs were emissions based, not a killer, but seat belts etc is something you REALLY don't wanna mess with and get wrong.


Kristian

yeh i will see wat they say i know all the people at the MOT centre so i will ask them cheers for your information

i asked about my proper harness with the twisty buckle...... aslong as it locks it reet

It was a few years ago now, but my old Alfasud went through an MOT with just two race seats and full race harnesses.

(I needed an MOT for tarmac rallies even though they were all off-road)

Apparently hydraulic handbrakes are ok for the MOT now too, they were not allowed back then so a secondary cable had to be rigged up just for the test...