Technical Wiper and washer problem

Currently reading:
Technical Wiper and washer problem

thelandlord

New member
Joined
Oct 8, 2015
Messages
1
Points
1
Hi there, just bought my daughter an eco multijet with a couple of minor issues, when pulling the wiper stalk back it neither squirts or wipes all other functions work, had steering wheel off and opened unit up and all seems ok with the contacts, not getting power to pump. Any suggestions before I buy a used unit to try. Thanks Paul
 
In order to wipe... you need to keep pulling for 5-6 seconds.

Does it work when pushing the stalk .. for the hatch window.
About power to the pump.. are you sure? did you use a multimeter to measure?
Did you hardwire to check if the pump works?
Are you sure the pipes are not just disconnected?

Start with the fuses.....check the relays.. the basics.
 
My bravo has a problem which it's switch module which controls the washers requiring a large amount of backwards force to create the switch.

But more than likely it's a blown fuse if the motor was used during winter and has drawn too much current. If the fuse is fine check the output power and ground supply at the terminal for the motor.
 
My stalk needs pulling back quite hard to spray water. The MOT tester was going to fail me until I showed him how to do it.
I imagine you have given it some welly though before stripping it. Not sure if mine is faulty or designed that way. Hope you figure it out.
 
Back
Top