Hi i have a 2008 1.9 multijet diesel Bravo. When i first turn the car on, it is fine, then after 5 minutes or so it goes into Limp Mode. After reading loads of stories on the internet, i changed the MAP sensor. That didn't work, Eventually, i took it to my local garage and they done a diagnostic test which says it is an air valve. However, the garage say they have checked that and can see it is working fine. They said i should take it to Fiat....i can only imagine how much that will cost. Any ideas on what i should check, or should i change the MAF??

its my first time posting on here...so I hope i have posted in the right section

thanks in advance for any suggestions

when they greet you at fiat, thats already 1hour of labor
did they tell you what error code it was?

flisko said:

when they greet you at fiat, thats already 1hour of labor
did they tell you what error code it was?

Click to expand...

P2015......which is something to do with swirl flaps......but the garage said they were working fine...they why they suggested going to fiat

I also nioticed that the breather pipe from the oil has a split in it......No where does them and so fiat charged me £44


would this also make it go into limp mode?