I need a Fiat Bravo front bumper removal guide!

Hello everyone,

Fiat Bravo 2008 1.4 90hp

I want to change my front bumper personally. Searching all over the websites, I didn't find anything about front bumper removal guide, videos or images. I ordered a front bumper assembly kit and I received original Fiat screws but without any clips... Had anyone tried to remove the front bumper and maybe have some photo? I also want to known if I need some clips(how many) and also if there are some clips needed which is the part number of them. I think i don't have all the screws and clips on the old front bumper. Thank you.

It's only screwed on, 4 Philips screws in each wheel arch, 4 torx screws under bumper just behind front splitter, 4 more torx on top of bumper, don't forget to unplug/ remove fog light bulbs then pull from the corner of bumper

Thank you! I received the Philips and torx screws... But my question is... Those Philips screws doesn't screw into some clips? Does them screw directly into plastic? Because my old front bumper doesn't have all the screws. The screws from the wheel arch, are completely missing.

They go through the wheel arch into the bumper, i think into metal tabs, apart from the top one, goes through the bumper into the wing, there aren't any clips

Re: I need a Fiat Bravo front bumper removal guide!

Bumper removal is easy and intuitive. BUT... the tabs on the retainers are very very very brittle. My bumper - removed to fit a second horn - is now held on by a few of the many push onto tabs. I think a supply of wooden lollipop sticks to insert into the relevant slots would minimise the risk. Fog light wires are a bit of a pain to remove but the bulb holder comes with new bulbs from Fiat, so if you bust one, as I did, its not a disaster.