Technical 500 1.2 Fuel Cut off Unavailable Just Repaired Gearbox

Currently reading:
Technical 500 1.2 Fuel Cut off Unavailable Just Repaired Gearbox

Strauss84

New member
Joined
Mar 13, 2017
Messages
5
Points
1
Hi Guys

My wife bought a 2013 500 1.2 Lounge last year and is out of Warranty

Im new here and desperately need your help, at 40000 kms I had to have the Gearbox bearings replaced....I had no prior issues with the car.

Now after approximately 30 min of driving the Fuel cut off is unavailable warning pops up. I have tried to reset is via the manual but the moment i start and drive for a bit i get the warning again.

The Battery is in perfect condition.

The car has "Stalled" While driving twice in this week. I am seriously confused.

The gearbox repair company have no idea whats going on either.

Any ideas ? Suggestions ? I am trying to avoid going to Fiat as after the gearbox repair i am broke as fork.

Regards
Dane
 

Hello and welcome

Now after approximately 30 min of driving the Fuel cut off is unavailable warning pops up. I have tried to reset is via the manual but the moment i start and drive for a bit i get the warning again.

Fuel cutoff on the 500 is implemented via the airbag ECU. Check all connections, then it's time to run diagnostics - multiecuscan or examiner.
 
jrkitching

Thank you! I will check with one of my customers to see if they can assist, I work in the Tyre industry so it has its perks. I will post my findings.

Just hope it is nothing major, I don't understand how a gearbox repair could screw this up.

Regards
 
So...I actually forgot we had a diagnostic machine at work. these are the errors below.

Body Computer
B1053 Inertia Switch Command Engine Control Node(FIS) - Where is this?

Engine Management

P0812 - Reverse Switch - Found - Reverse lights work (note says short to battery)
U0001 - C - CAN line Error - No Idea

ABS
C1221 - Engine Control NCM


Still Struggling though
 
So...I actually forgot we had a diagnostic machine at work. these are the errors below.

Body Computer
B1053 Inertia Switch Command Engine Control Node(FIS) - Where is this?

Engine Management

P0812 - Reverse Switch - Found - Reverse lights work (note says short to battery)
U0001 - C - CAN line Error - No Idea

ABS
C1221 - Engine Control NCM


Still Struggling though

How many of the codes can clear..

What stays..and what comes back.
 
How many of the codes can clear..

What stays..and what comes back.

Ok Cleared all the codes.. ran another scan to be sure.

Started the car for less than a minute and scanned again

now i get this error:
B10AA PROXI Configuration Control
 
Worth doing a proxy alognment to see if they find each other.

Can Someone Elaborate on the term "Proxy Alignment" I'm a layman here.

I have googled till i was blue in the face but no real description on what actually happens here.
 
Back
Top